BlieSMa T25S-6 Dome Tweeter Matched Pair
Stock details
| Diameter of the cone / dome | |
| Impedance | |
| Sensitivity (SPL at 1 m / 2.83 V) | |
| Power Handling (RMS) | |
| Resonance frequency (Fs) |
| Maximum linear deflection (Xmax) | |
| Total Q (Qts) | |
| Electromagnetic Q (Qes) | |
| Mechanical Q (Qms) | |
| DC resistance (Re) | |
| Voice coil inductance (L_e) | |
| BL product (BL) | |
| The surface area of the cone (Sd) | |
| Moving mass with air load (Mms) | |
| Tweeter type | |
| Voice coil diameter |
BlieSMa is a German manufacturer that builds high-end drivers by hand in small batches; every unit is measured before it leaves the workshop. The tweeters come as a matched pair: the frequency and sensitivity curves of the two units match closely, giving a precise and stable stereo image. The T25S-6 is the 91 dB member of the T25 series, with 2 mm linear excursion and a 940 Hz resonance frequency.
- Sensitivity: 91 dB (2.83 V / 1 m)
- Inductance (Le): 0.008 mH
- Qms: 1.35
- Qes: 0.82
- Qts: 0.51
- Xmax: 2 mm
- DC resistance (Re): 5.2 Ω
- Power handling (RMS): 100 W
- Impedance: 6 Ω
- Resonance frequency (Fs): 940 Hz
- Voice coil diameter: 24 mm
- Moving mass (Mms): 0.16 g
- Cone area (Sd): 5.7 cm²
- BL: 2.6 Tm
A Qts of 0.51 and a low 0.16 g moving mass give accurate, fast treble. It is typically crossed at around 2 kHz in two-way speakers and 2.5–3 kHz in three-way designs; the 100 W power handling stays safe at high volume.
Design tip: always put at least a series capacitor in front of the tweeter, and without measurements choose a higher crossover point. Because of the high sensitivity, an L-pad or series/parallel resistor divider may be needed for level matching.
No reviews for this product yet.
Bought this product? Sign in to review it quickly!
Sign in to review










