Crossover Components
Low Pass Crossover | 80 Hz | 8 Ohm
Low Pass Crossover | 80 Hz | 4 Ohm
Dayton Audio Low Pass Speaker Crossover 12 dB/Octave, 4 Ohm, 600 Hz Assembled crossover
Intertechnik LU44/1.80/071 | 1.8 mH | 1.29 Ω | 3% | 21 AWG
ClarityCap CSA | 5.30 µF | 3% | 250 V
Mundorf MLGO100-1500 | 1500 µF | 20% | 100 V
Mundorf MR5-0.47 | 0.47 Ω | 5 W | 2% | Mresist MOX Metal-oxide Resistor
Mundorf MR5-0.68 | 0.68 Ω | 5 W | 2% | Mresist MOX Metal-oxide Resistor
Dynavox 3-Way Crossover | 1000/3200 Hz | 8 Ohm
Mundorf MLGO63-3300 | 3300 µF | 20% | 63 V
Mundorf MR5-0.82 | 0.82 Ω | 5 W | 2% | Mresist MOX Metal-oxide Resistor
Mundorf MR5-10 | 10 Ω | 5 W | 2% | Mresist MOX Metal-oxide Resistor
Intertechnik LP/ETZ Universal PCB Board | 120 x 85 mm
High Pass Crossover | 80 Hz | 4 Ohm
ClarityCap CSA | 5.60 µF | 3% | 250 V
Mundorf MR5-12 | 12 Ω | 5 W | 2% | Mresist MOX Metal-oxide Resistor
Mundorf MR5-1.20 | 1.20 Ω | 5 W | 2% | Mresist MOX Metal-oxide Resistor
PCB-S01 Cloverleaf Pitches Crossover Board | 10 x 15 cm
Read more: Crossover Components
A passive crossover decides which driver gets which part of the spectrum, and where and how steeply the bands hand over to each other. At least half of a well-designed speaker's sound is shaped here, not in the drivers themselves.
This section holds everything a crossover is built from: inductors, capacitors, resistors, circuit boards, driver protectors and ready-assembled networks. When refurbishing, start with aged electrolytic capacitors; for a new design, start by measuring the values precisely.























